Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Panneau de contrôle Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U. Aube Technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
TH146-N-U 1/12
TH146-N-U
Installation Guide
Non-programmable H/C Controller
The TH146-N-U electronic controller can be used with any of the fol-
lowing heating/cooling systems:
The following devices can be connected to the controller:
air recirculation fan
humidifier
dehumidifier or air exchanger
dual-register meter (dual energy)
remote control device (for the unoccupied mode)
CT280-3H3C control module
TH146 console with two wall anchors and mounting screws
AC144-03 outdoor temperature sensor (3 m or 10 ft) with mount-
ing clip (see section 2.7)
RC845 relay (see section 2.4)
AC146-410 plenum temperature sensor (see section 2.8)
CT241 telephone controller (see section 2.10)
Configure the control module according to your type of heating/cool-
ing system using DIP switches on the back of the module.
Install the control module near the heating/cooling system, away
from any heat source.
Install the console in a central location. Avoid locations with air
drafts (e.g., top of staircase or air outlet) or stagnant air (behind a
door). Do not install the console on a wall hiding air ducts nor
expose it to direct sunlight.
NOTE: If this controller replaces an old thermostat, any two of the
wires that were connected to the thermostat can be used to connect
the user console to the control module. The maximum wiring length
is 30 m (100 ft).
AC144-03 Outdoor
Temperature Sensor
TH146 User Console
CT280-3H3C Control Module
Removable
Connector *
Removable
Connector *
* To remove a connector from the control module, pry with a screwdriver.
1. Introduction
1.1
Applications
Heat pump
1H1C, 2H1C, 2H2C, 3H1C, 3H2C, 3H3C, 4H2C
HVAC
1H, 2H, 3H, 1C, 2C, 3C, 1H1C, 1H2C, 2H1C, 2H2C,
2H3C, 3H1C, 3H2C, 3H3C
1.2
Supplied Parts
1.3
Accessories
2. Installation
2.1
Control Module (CT280-3H3C)
2.2
User Console (TH146)
Heat pump
HVAC
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - TH146-N-U

TH146-N-U 1/12TH146-N-UInstallation GuideNon-programmable H/C ControllerThe TH146-N-U electronic contro

Page 2 - 3.1.3 Keypad Lock (SW1-3)

TH146-N-U 10/12Manual SettingIn manual setting, the user sets the humidity level (5 to 60%).1) Press th

Page 3

TH146-N-U 11/12

Page 4 - Wiring Tables

TH146-N-U 12/12Printed in USA 09/2011

Page 5

TH146-N-U 2/12 Choose a location about 1.5 m (5 ft) above the floor on an inside wall. Loosen the cap

Page 6

TH146-N-U 3/12With automatic heating/cooling mode changeover, there’s no needto adjust the controller a

Page 7 - Wiring Diagram: 3H2C HVAC

TH146-N-U 4/12Wiring TablesHeat PumpTerminal Device 1H1C 2H1C 3H1C 2H2C 3H2C 4H2C 3H3CTHConsole Connect

Page 8 - Configuration Menu

TH146-N-U 5/12Wiring Diagram: 2H1C Heat Pump — New InstallationAC146-410AC144-03CT241HumidifierDehumidi

Page 9

TH146-N-U 6/12Wiring Diagram: 3H2C Heat Pump — Add-on InstallationAC146-410AC144-03CT241FaultDefrostRev

Page 10 - 8. Technical Assistance

TH146-N-U 7/12Wiring Diagram: 3H2C HVACAC146-410AC144-03CT241Cooling Unit 1Cooling Unit 2Heating Unit 1

Page 11

TH146-N-U 8/12Configuration MenuItem HP HVAC Parameters Display Options Default Description1  Tempera

Page 12 - Printed in USA 09/2011

TH146-N-UUser’s GuideNon-programmable H/C ControllerTH146-N-U 9/12Press the Mode button to place the sy

Commentaires sur ces manuels

Pas de commentaire